Yes defo only one.....

Cheers Hoarder that will put  my  mind at  rest .I actually  dropped  it twice  , first time  never  knew until  I put  it back  together  then  found  it on  floor  then second  time dropped  it while  trying  to  be careful  putting  it  together again. Pesky  little thing  it  is.

just read on the technical question and answers  that there  should  also  be a spring  . I never saw  or  found  that lying  about.
has anyone  got the  diagram of the  twist  grip whick was spoken about  on that thread?

There is a diagram on the website somewhere i shall have alook and let you know if i find it, yes there is a little spring it goes in the hole and then the ball bearing sits on top.

Hope this helps...

Cheers Hoarder , I suppose  I better  get  back to the  garage  floor and see if  I  can find a spring.It  seems  to be  working  ok without  it if it  isnt  in  it.

You have PM

As far as remember there is just the one mate, u have moved the plate up or down (to where the slot is which reveals the colours) this has caused that one bearing to fall out of the recess, once u have re fitted the spring i am pretty sure you have sorted it!! as i had 3 grifters back in the day i went through a few cables and its all coming back to me now!    

--Last edited by mk2 grifter gaz on 2007-12-07 22:31:26 --

one spring , one ball bearing deffo

yeah just the one.

h no its happening again , i have bought 5 into the warmth of my front room so she can warm up , dry off and listen to some cooooool 80,s music oh and get worked on , and remember its only a little , i have replace her missing frame cable clip and fitted a rear brake block .
She needs a rear nudguard but the one i have is going to be fitted to baby blue .

Today as im Griftering most of the day , i am going to refit a rear mudguard to 5 which will then make her pretty much complete and ready to ride , then the brakes will need refitting and she is there .

Another job jobbed

DONE  

--Last edited by steve edwards on 2008-08-20 12:18:01 --